Display Poe Interface Power - 3Com 5500-EI PWR Reference Manual

Ethernet1/0/1
Ethernet1/0/2
Ethernet1/0/3
Ethernet1/0/4
Ethernet1/0/5
Ethernet1/0/6
Ethernet1/0/7
Ethernet1/0/8
......
<Omitted>
Table 1-2 display poe interface command output description
PORT INDEX
POWER
ENABLE
MODE
PRIORITY
STATUS

display poe interface power

Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Port type and port number.
on enable signal
on enable signal
off enable signal
off enable signal
off enable signal
off enable signal
off enable signal
on enable signal
Field
1-3
low Standard PD was detected
low Standard PD was detected
low detection is in process
low detection is in process
low detection is in process
low detection is in process
low detection is in process
critical Standard PD was detected
Description
Port index
Power status on the port: ON/OFF
PoE enabled/disabled status on the port
PoE mode on the port:
signal: PoE through the signal cable
spare: PoE through the spare cable
PoE priority of the port:
critical: Highest
high: High
low: Low
PoE status on the port:
user command set port to off: PoE to the port
is turned off by the user
Standard PD was detected: A standard PD is
detected
PD detection is in process: PDs are being
detected
If the poe enable command is configured on
a port, and the port is not connected to a
standard PD (for
" non-standard PD connected" will be
displayed.
example, a PC),