Forwarding Database Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Table 112 Spanning Tree Port Configuration Menu options
Command
link auto|p2p|shared
edge disable|enable
fastfwd disable|enable
on
off
cur

Forwarding Database configuration

Command: /cfg/l2/fdb
[FDB Menu]
The following table describes the Forwarding Database Configuration Menu options.
FDB Configuration Menu options
Table 113
Command
static
aging <0-65535>
cur
Description
Defines the type of link connected to the port, as follows:
auto—Configures the port to detect the link type, and automatically match its
settings.
p2p—Configures the port for Point-To-Point protocol.
shared—Configures the port to connect to a shared medium (usually a hub).
This command only applies when RSTP is turned on. See the "Common Internal
Spanning Tree configuration" section for more information.
Enables or disables this port as an edge port. An edge port is not connected to a
bridge, and can begin forwarding traffic as soon as the link is up. Configure
server ports as edge ports (enabled).
This command only applies when RSTP is turned on. See the "Common Internal
Spanning Tree configuration" section for more information.
Enables or disables Port Fast Forward on the port.
Enables STP on the port.
Disables STP on the port.
Displays the current STP port parameters.
static - Static FDB Menu
aging - Configure FDB aging value
cur - Display current FDB configuration
Description
Displays the Static FDB Configuration Menu.
Configures the aging value for FDB entries. The default value is 300.
Displays current FDB parameters.
Configuration Menu
150