Installing Or Removing A Hard Drive; Installing A Hard Drive; Figure 22. Removing Hard Drive Carrier From Chassis - Intel TIGI2U - Carrier Grade Server User Manual

Platform Installations and Upgrades

Installing or Removing a Hard Drive

Up to two hot-swappable SCSI drives can be installed in your chassis. It is not necessary
to remove the chassis cover to add or replace a hot-swap hard drive. It is necessary to
remove the front bezel from the chassis.
CAUTION
®
The Intel Carrier Grade Server TIGI2U does not support all hard
drives. To see a list of validated manufacturers and hard drive
types, see:
http://support.intel.com/support/motherboards/server/TIGI2U

Installing a Hard Drive

1. Remove the front bezel. For instructions, see
2. Press in on the green latch on the front of the hard drive carrier (see letter "A").
3. Pull out on the black lever to slide the carrier from the chassis (see letter "B").
4. Remove the hard drive from its wrapper and place it on an antistatic surface.
5. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
6. With the drive circuit-side down, position the connector end of the drive so that it is
facing the rear of the drive carrier (see letter "A").
46

Figure 22. Removing Hard Drive Carrier from Chassis

"Removing the Front Bezel."
®
Intel Carrier Grade Server TIGI2U User Guide