Server Utilities; Using The Bios Setup Utility; Starting Setup; If You Cannot Access Setup - Intel TIGI2U - Carrier Grade Server User Manual

Server Utilities

Server Utilities

Using the BIOS Setup Utility

This section describes the BIOS Setup Utility options, which is used to change server
configuration defaults. You can run BIOS Setup with or without an operating system being
present. See "Additional Information and
Specification where you will find details about specific BIOS setup screens.

Starting Setup

You can enter and start BIOS Setup under several conditions:
When you turn on the server, after POST completes the memory test

When you have moved the CMOS jumper on the server board to the "Clear CMOS"

position (enabled)
In the two conditions listed above, during the Power On Self Test (POST), you will see this
prompt:
Press <F2> to enter SETUP
In a third condition, when CMOS/NVRAM has been corrupted, you will see other prompts
but not the <F2> prompt:
Warning: CMOS checksum invalid
Warning: CMOS time and date not set
In this condition, the BIOS will load default values for CMOS and attempt to boot.

If You Cannot Access Setup

If you are not able to access BIOS Setup, you might need to clear the CMOS memory. For
instructions on clearing the CMOS, see "Clearing the CMOS".

Setup Menus

Each BIOS Setup menu page contains a number of features. Except for those features
that are provided only to display automatically configured information, each feature is
associated with a value field that contains user-selectable parameters. These parameters
can be changed if the user has adequate security rights. If a value cannot be changed for
any reason, the feature's value field is inaccessible.
Table 5 describes the keyboard commands you can use in the BIOS Setup menus.
Intel® Carrier Grade Server TIGI2U User Guide
Software" for a link to the Technical Product
82