Replacing The Server Board; Removing The Server Board - Intel TIGI2U - Carrier Grade Server User Manual

Platform Installations and Upgrades

Replacing the Server Board

®
The Intel Carrier Grade Server TIGI2U uses the Intel
replace the server board, the following components must be removed:
All cable connections on the server board

Heat sink(s)

Processor(s)

All DIMMs

PCI riser assembly

Four-fan assembly

To replace the server board, use the following instructions.
CAUTION
Before replacing any of the server boards, you must first take the
server out of service, turn off all peripheral devices connected to the
system, turn off the system by pressing the power button, and unplug
the AC power cord from the system or wall outlet or disconnect the
DC mains.

Removing the Server Board

1. Power down the server system and unplug all peripheral devices and the AC power
cable or the DC mains.
2. Remove the chassis cover. For instructions, see
3. Remove the PCI riser assembly. For instructions, see
steps 3 – 4.
4. Remove the processor air duct. For instructions, see
Duct."
5. Remove all DIMMs. For instructions, see
6. Remove the heat sink and processor. For instructions, see
7. Remove the four-fan assembly. For instructions, see
Assembly."
8. Disconnect all cables from the server board.
9. Remove the eight screws that attach the server board to the chassis.
10. Lift the server board from the chassis. Use caution in pulling it out from beneath the
Serial B connector at the rear of the chassis.
®
Intel Carrier Grade Server TIGI2U User Guide
®
Server Board SE7520JR2. To
"Removing the Chassis Cover."
"Removing a PCI Add-in Card,"
"Removing the Processor Air
"Removing DIMMs."
"Removing the Processor."
"Removing the Four-Fan
73