Table of Contents
Advertisement
TL-WA7110ND
1.
Connect the MAIN (PoE) port of TL-WA7110N to the POE port of the Power Injector with an
Ethernet cable.
2.
Connect the PC to the LAN port of the Power Injector with an Ethernet cable.
3.
Plug one end of the Power Adapter into the DC jack on the Power Injector, and the other end
in electrical wall socket.
4.
Power on the PC(s) and notebook(s).
2.3.2
AP Router
Figure 2-2 Hardware Installation of the TL-WA7110ND in AP Router mode
1.
Connect the MAIN (PoE) port of TL-WA7110N to the POE port of the Power Injector with an
Ethernet cable.
2.
Connect the DSL/Cable Modem to the LAN port of the Power Injector with an Ethernet cable.
3.
Plug one end of the Power Adapter into the DC jack on the Power Injector, and the other end
in electrical wall socket.
4.
Power on the PC(s) and other connected devices (such as the ADSL modem).
Note:
In this mode, the LAN port of the Power Injector (connected to the LAN port of the Device) works
as the WAN port.
2.3.3
Access Point
This operation mode allows wireless stations to access.
Figure 2-3 Hardware Installation of the TL-WA7110ND in Access Point mode
1.
Connect the MAIN (PoE) port of TL-WA7110N to the POE port of the Power Injector with an
Ethernet cable.
2.
Connect the LAN port of the Power Injector to the wired network port with an Ethernet cable.
3.
Plug one end of the Power Adapter into the DC jack on the Power Injector, and the other end
in the electrical wall socket.
4.
Power on the notebook(s) and other connected devices (such as the Wired Router).
150Mbps High Power Wireless Access Point User Guide
7
Advertisement
Table of Contents
