View Button - Alesis ANDROMEDA A6 Reference Manual

modulate the tempo of the sequence. The Sync/Mod parameters table that describes
their functions can be found on page 78.

VIEW Button

Pressing this button recalls the page of Sequencer parameters that was last used (it defaults to the
page). Using this button to enter the Sequencer edit mode allows you to examine the
current settings without making any changes. You can, of course, change any setting but you
don't have to when using a
Sequencer Parameters
This section describes the parameters of the Sequencer. The summary table below
shows the Sequencer's parameter names – listed in the rows under under the
numbers – with their associated page (parameter group) in the
KNOB
column. The tables on the following pages provide operational details of each
display page.
SOFT KNOB
PAGE TAB
Pressing this button turns the sequencer on or off. This is the same as pressing the
button in the
Use soft button 8 to select a Step ( – ) on the
A A6 R
NDROMEDA EFERENCE
button
VIEW
1 2 3
section on the front panel.
SEQUENCER
M
ANUAL
Chapter 2: Playing the A6
START/STOP Button
Pressing this button enables or
disables the Sequencer. This is a
programmable parameter that is
saved with each Program and
with each Mix Channel
separately. So, you can have the
sequencer enabled for a program
in Mix Mode and disabled for
that program in Program Mode.
Remember, the sequence will
not start until it receives a
trigger, normally the keyboard.
SYNC/MOD Button
Pressing this button displays the
Sequencer's
screen. The Sync/Mod page of
parameters allows you to
4 5 6
page for editing.
page on the
SOFT
PAGE TAB
7 8
START/STOP
73