Alesis ANDROMEDA A6 Reference Manual page 259

CC MAP Page Parameters
The fourth page of the GLOBAL menu allows you to set which of the 120 MIDI
Continuous Controller messages will be transmitted by the Andromeda's controllers.
PAGE PARAMETER
CC MAP
PED CC
Pedal
FSW CC
Footswitch
RIBVCC
Ribbon Value
RIBLCC
Ribbon Left
RIBRCC
Ribbon Right
CTL NUM
Continuous
Controller
Number
CC IN
Continuous
Controller Input
A A6 R
NDROMEDA EFERENCE
OPTIONS
or RANGE DESCRIPTION
OFF This parameter determines what MIDI
Continuous Controller number will be
1 ··· 120
transmitted by a pedal plugged into the
CV/PEDAL jack on the rear panel. Note that if
you assign the CC Pedal to CC 7 (corresponding
to MIDI Volume), the pedal will automatically
control the A6's Master Volume without the
need to set up a dedicated Mod Route.
OFF
Sets MIDI Continuous Controller number that
will be transmitted by a pedal plugged into the
1 ··· 120
SWITCH jack on the rear panel. When set to
SSHOLD
SSHOLD
send out a MIDI Start Message, and releasing it
SSTOGL
will send a MIDI Stop Message. When set to
SSTOGL
a MIDI Start Message and pressing it again will
send a MIDI Stop Message. With these settings,
you can use the Footswitch to control an external
sequencer.
OFF Sets MIDI Continuous Controller number that
will be transmitted by the entire Ribbon. Note
C20C52
that this is a two-byte quantity requiring two
C31C63
Continuous Controller numbers.
OFF Sets MIDI Continuous Controller number that
will be transmitted by the left part of the Ribbon
1 ··· 120
when it is split in the middle.
OFF Sets MIDI Continuous Controller number that
will be transmitted by the right part of the
1 ··· 120
Ribbon when it is split in the middle.
CC A-H Selects which letter (A through H) of the A6's
Modulation sources will be mapped to a
particular incoming Continuous Controller
number. CC A etc. appear as Sources in MOD
menus all over the Andromeda, allowing MIDI
control of individual synth settings in real time.
0··· 127
Sets what CCnumber will be used to control the
Mod source currently selected by
above.
M
ANUAL
Chapter 12: MIDI Functions
, pressing down on the Footswitch will
, pressing the Footswitch once will send
CTL NUM
257