Adjust The Mix; Setting Input Levels - Alesis ANDROMEDA A6 Reference Manual

Chapter 10: Using Effects
Now we're ready to go back to the
be useful for adding a little warmth to a hall program. By setting the frequency to
237Hz and the Level to 100, we can add a touch of warmth to our hall program.
15. Press soft button
16. Using the soft knobs, set
A M
DJUST THE
Now, you can go back to the
for whatever balance of "wet and dry" you want.

Setting Input Levels

For quietest operation, it's best in most cases to leave the input level high, and if you
want less reverb, to turn the output level down. The input level should be high
enough to be well above the noise floor to get the best dynamic range, but not so
high that it clips the digital effects engine itself. If you see the word
the lower right side of an effects page, lower the
Setting Output Levels
On the other hand, it is possible to set the Output so high that it can clip the final
summing amps of the Andromeda. If this happens, you'll hear it. Turn off the
EFFECTS ON/OFF
If it's the effect, restructure your gain. Sometimes this means going all the way back
to the levels of the
To "SOLO" the Effects
To hear the reverb and only the reverb while you're listening to the Main Outputs,
simply press the
program audio from the Main Output. The effects will still be feeding the output,
without any "dry" signal mixed in.
210
PARAM1
( ) to return to that page.
PARAM1
2
BOOST to
IX
CONFIG
switch to make sure it's the effect, and not something in the program.
.
PRE FILTER MIX
switch on the far right of the top panel to remove the
OUTPUT
page, parameters 2 and 3. Bass Boost can
100 and BASSF to 0.237.
page and adjust the
SEND
level on the
SEND
A A6 R
NDROMEDA
and levels
OUTPUT
appear in
CLIP
page.
CONFIG
M
EFERENCE ANUAL