Alesis ANDROMEDA A6 Reference Manual page 140

Chapter 6: Modulation and Envelopes
TIME
—
TIME
Parameters
(continued)
➟
RELEASE 1
➟
RELEASE 2
138
LINEAR
SHAPE
EXP 1, 2 & 3
LOG 1, 2 & 3
SCURV1 & 2
R1TIME
131.05 S
Release 1 Time
R2TIME
131.05 S
Release 2 Time
Designed after the
function,
SHAPE
or deceleration attributes) of the envelope's
Attack, Decay 1, Decay 2, Release 1 and Release
2 stages.
This parameter is active at all times for all time
parameters except
slope for a time parameter, select the parameter
by tabbing with soft button
to select the desired slope. The display will
5
show an envelope graphic that will depict the
slope selected for each stage.
See the topic on the following page for a
SHAPE
detailed description of the A6's stage slopes.
OFF ···
The amount of time it takes the envelope to
decrease from the
; this is the envelope stage entered when
2 LEVEL
a Note Off occurs.
The amount of time it takes the envelope to
2 M ···
decrease from the
2 milliseconds to 131.05 seconds. Note that
Release 2 (and also Attack, previous page)
differs from the other envelope times in that a
2ms time minimum is required.
Important Note: If
value, the envelope will enter into "infinite
release". This means that when the envelope
reaches this stage, it will hold at its
page 141) indefinitely until you change to
another Program or Mix, or turn the A6 off.
To alert you that
maximum, the
HOLD
that envelope will light.
A A6 R
NDROMEDA
function of the
CURVE
refers to the slope (acceleration
. To select a particular
DELAY
, then use soft knob
1
to the
SUSTAIN LEVEL RELEASE
to zero, from
RELEASE 2 LEVEL
is set to its maximum
R2TIME
R2LEVL
has been set to its
R2TIME
LED on the front panel for
M
EFERENCE ANUAL
PORTA
(see