Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 93

Performing an In-Place Upgrade on a ZENworks Secondary Server
You must upgrade the ZENworks Primary Server before upgrading ZENworks Secondary Servers.
For step-by-step information, see
Server" on page 92.
1 Make sure that the server is running, and meets the requirements. See
Server Requirements," on page
2 At the Linux server, mount the Novell ZENworks 7.3 Linux Management media by using the
mount device mountpoint
For example,
mount /dev/cdrom /zlm73.
mount device mountpoint
If you are using an ISO image rather than a physical media, copy the ISO to a temporary folder
on the Linux server, then mount the image using the following command.
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace
tempfolderpath
the path to the file system location where you want to mount the image. The path specified by
must already exist.
mountpoint
For example:
mount -o loop /zlm73/ZEN73_LinuxMgmt.iso /zlm73/install
3 Log in as , then start the upgrade program form the mount point by running the following
root
command:
./zlm-upgrade
4 When prompted to upgrade ZENworks Linux Management, enter
5 Review the Software License Agreement, pressing Page Down to scroll down the page, then
enter to accept the agreement.
Y
The install program stops ZENworks services, subscribes to the upgrade channels, upgrades
RPMs, upgrades zmd, runs upgrade scripts, and then restarts the ZENworks services.
6 Enter when you are asked if you are upgrading a ZENworks Primary Server.
N
7 Enter when you are asked if you have upgraded the ZENworks Primary Server.
Y
Ignore any "failed to stop" errors that you receive. For example, you receive an error indicating
that eDirectory could not be stopped, but it was already stopped when you executed
novell/zenworks/bin/zlm-config --stop
The upgrade program stops ZENworks services, subscribes to the upgrade channels, upgrades
RPMs, upgrades zmd, and runs upgrade scripts.
After the upgrade is complete, the ZENworks services are restarted. this might take a few
minutes.
8 Delete
ostargets.xml
at the server console prompt.
ostargets.xml
9 Manually copy
ostargets.xml
ZENworks Primary Server to
Server.
"Performing an In-Place Upgrade on the ZENworks Primary
23.
command.
with the path to the temporary folder and replace
in
by executing
rm /var/opt/novell/zenworks/lib/www/
from
/var/opt/novell/zenworks/lib/www/
/var/opt/novell/zenworks/lib/www/
Section 2.1, "ZENworks
to continue.
Y
Step 6 on page 92.
on the Secondary
Upgrading to ZENworks 7.3 Linux Management
with
mountpoint
/opt/
on the
93