Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 42

IMPORTANT: If other services run on port 80, the installation will fail; the server cannot run
other services on port 80. If Apache or another service is binding to port 80, remove the service
or change the service's port.
For example, change the Apache2 web server's Listen Port (on SLES 9 SP3 as found in
apache2/ listen.conf
run zlm-config.
2 If the
change it as follows:
Your_IP_address hostname.localdomain hostname
3 (Conditional) If you plan to use an existing database for the ZENworks Data Store, make sure
you've prepared the database. See
Store," on page
4 At the Linux server, mount the product media of the ZENworks Linux Management version
you want to install by using the
Use the Novell ZENworks 7.3 Linux Management Server installation media to install
ZENworks 7.3 Linux Management.
Use the Novell ZENworks 7.3 Linux Management with Interim Release 1 Server media to
install ZENworks 7.3 Linux Management with IR1.
Use the Novell ZENworks 7.3 Linux Management with Interim Release 2 Server media to
install ZENworks 7.3 Linux Management with IR2.
For example, to install ZENworks 7.3 Linux Management, mount the product media by using
mount /dev/cdrom /zlm73
If you are using an ISO image rather than a physical media, copy the ISO to a temporary folder
on the Linux server, then mount the image using the following command:
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace tempfolderpath with the path to the temporary folder and replace mountpoint with the
path to the file system location you want to mount the image. The path specified by mountpoint
must already exist.
For example:
mount -o loop /zlm73/ZEN73_LinuxMgmt.iso /zlm73/install
5 Log in as
following command:
./zlm-install
IMPORTANT: If you want to install ZENworks 7.3 Linux Management on a SUSE
Enterprise 11 device, you can install it from the text mode console (tty) rather than the X-
session of the device. To install it by using the X-session of the device, update the gpg2
package with gpg2 2.0.9-25.25.1 version or later and update the gpg2-lang package with gpg2-
lang 2.0.9-25.25.1 version or later. For more information, see "Upgrade" in the
Linux Management with Interim Release 1 Readme (http://www.novell.com/documentation/
zlm73/readme/readme_zlm_73_ir1.html).
The steps in this procedure perform a standard installation of ZENworks Linux Management.
Depending on your situation, additional options can be used with the
For more information, see
42 Novell ZENworks 7.3 Linux Management Installation Guide
) from 80 to 81. Make sure the Apache service is shut down and then
file contains the entry 127.0.0.2 hostname.localdomain hostname, then
/etc/hosts
33.
.
, then start the installation program from the mount point by running the
root
Appendix VI, "Appendixes," on page
Section 3, "Preparing the Database for the ZENworks Data
mount device mountpoint
command.
®
Linux
ZENworks 7.3
command.
zlm-install
119.
/etc/