Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 49

System clock synchronization is required to ensure correct operation of the ZENworks system.
If the two servers are not synchronized, the installation fails.
After synchronizing the clocks, restart eDirectory and all ZENworks Linux Management
services on each server that had its clock's time changed. To restart the ZENworks Linux
Management services, enter the following command:
/opt/novell/zenworks/bin/zlm-config --restart
7 At the intended Secondary Server, mount the product media of the ZENworks Linux
Management version you want to install by using the
Use the Novell ZENworks 7.3 Linux Management installation media to install ZENworks
7.3 Linux Management.
Use the Novell ZENworks 7.3 Linux Management with Interim Release 1 Server
installation media to install ZENworks 7.3 Linux Management with IR1.
Use the Novell ZENworks 7.3 Linux Management with Interim Release 2 Server
installation media to install ZENworks 7.3 Linux Management with IR2.
For example, to install ZENworks 7.3 Linux Management, mount the product media by using
mount /dev/cdrom /zlm73
If you are using an ISO image rather than a physical media, copy the ISO to a temporary folder
on the Linux server, then mount the image using the following command:
:
mount -o loop /tempfolderpath/isoimagename.iso mountpoint
Replace tempfolderpath with the path to the temporary folder and replace mountpoint with the
path to the file system location you want to mount the image. The path specified by mountpoint
must already exist.
For example:
mount -o loop /zlm73/ZEN73_LinuxMgmt.iso /zlm73/install
8 Log in as , then start the installation program from the mount point by running the
root
following command:
./
zlm-install
NOTE: The steps in this procedure perform a standard installation of ZENworks Linux
Management. Depending on your situation, additional options can be used with the
command. For more information, see
install
page 121.
If you do not have the X Window System installed (for example, you installed a Minimal
installation of SUSE Linux Enterprise Server 9), you must install the glib2, XFree86-libs-32
bit, and compat-32bit packages and use the -x option while installing the ZENworks Agent. For
more information, see
For more information about installing ZENworks Linux Management on a SUSE Linux
Enterprise Server with a Minimal installation, see
9 When prompted to install ZENworks, enter
10 Review the Software License Agreement, pressing Page Down to scroll down the page, then
enter to accept the agreement.
Y
Installation of the software begins. There are ten software components to install. Installation
progress is displayed for each component.
.
"-x" on page 122.
to continue.
Y
mount device mountpoint
Section A.1, "Installation Options," on
"Operating Systems" on page
Installing a ZENworks Secondary Server
command:
zlm-
23.
49