Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - INSTALLATION GUIDE 07-20-2009 Installation Manual page 43

If you do not have the X Window System installed (for example, you installed a Minimal
installation of SUSE Linux Enterprise Server 9), you need to install the glib2, XFree86-libs-32
bit, and compat-32bit packages to the server before installing ZENworks Linux Management.
When you install ZENworks Linux Management on the server, you must use the
avoid dependency problems. Running
X Window System. In
zmd-gconfpolicyenforcer, novell-zenworks-zmd-rmagent, and vnc components.
For more information about installing ZENworks Linux Management on a SUSE Linux
Enterprise Server with a Minimal installation, see
6 When prompted to install ZENworks, enter
7 Review the Software License Agreement, press Page Down to scroll down the page, then enter
to accept the agreement.
Y
Installation of the software begins. There are ten software components to install. Installation
progress is displayed for each component.
If you are installing on a SUSE Linux Enterprise Server 10 (SLES 10) device, a message might
be displayed informing you that some packages are already installed (for example, rug, zmd-
inventory, or zen-updater). Some packages that ship with ZENworks Linux Management also
ship with SLES 10. Depending on the versions of these packages, you might be prompted to re-
install these packages, which might overwrite configuration changes you have made. Press
continue.
If you are installing on a SUSE Linux Enterprise Server 11 (SLES 11) 64-bit device, a message
might be displayed informing you that the nici packages are already installed. You might be
prompted to reinstall these packages, which might overwrite configuration changes you have
made. Press to continue.
Y
8 When installation of the software is complete, enter
ZENworks Primary Server and Management Zone.
9 If you have multiple interfaces configured, you are prompted to enter the IP address to which
you want to configure your server. Enter the IP address of the device. By default, the IP address
of the first interface is selected as the device.
10 Provide the appropriate responses to the following prompts:
Is this the first server in your system?: Enter
Enter a unique Management Zone name: Enter the name you want to use for your
ZENworks Management Zone. For example, Novell_Boston. The name cannot be the
same as any other ZENworks Management Zone in your network environment. If you use
Novell eDirectory, it cannot be the same name as your eDirectory tree name.
Enter an Administrator password: Enter the password you want assigned to the default
ZENworks Administrator account.
Repeat the Administrator password: Re-enter the password.
Do you want ZENworks to install and set up a local PostgreSQL database for you?:
If you want to use a new PostgreSQL database for the ZENworks Data Store and have it
located on the Primary Server, enter
or Oracle database, either on the Primary Server or on a remote server, enter
11 Choose to continue with a Self-Signed Certificate or to import your own PKCS12 certificate. If
you choose to import your own PKCS12 certificate, you must enter the location of the
certificate and the password.
./zlm-install –x
Step 8 below, you must agree when it says that the installation lacks the
to continue.
Y
for Yes. If you want to use an existing PostgreSQL
Y
skips any packages that require the
"Operating Systems" on page
to run and configure the
Y zlm-config
for Yes.
Y
Installing the ZENworks Primary Server
switch to
-x
23.
to
Y
for No.
N
43