Set Up A Gateway-To-Gateway Vpn Configuration - NETGEAR DGN2200v1 User Manual

Set Up a Gateway-to-Gateway VPN Configuration

This section describes how to use the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
by these VPNC-recommended parameters, see
on page 118 for information about how to set up the VPN tunnel.
Circumstances
Follow this procedure to configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
IP: 192.168.0.1
14.15.16.17
Gateway A
Figure 21. Gateway-to-gateway VPN tunnel
Set the LAN IPs on each modem router to a different subnet and configure each correctly for
the Internet. The subsequent examples assume the settings shown in the following table.
Table 6. Gateway-to-Gateway VPN Tunnel Configuration Worksheet
Parameter
Connection Name
Pre-Shared Key
Secure Association
Perfect Forward secrecy
Encryption Protocol
Authentication Protocol
Diffie-Hellman (DH) Group
Key Life in seconds
IKE Life Time in seconds
VPN Endpoint
Gateway_A
Gateway_B
108 | Chapter 8. Virtual Private Networking
on page 97. If you have special requirements not covered
Table 4
VPN tunnel
Value to Be Entered Field Selection
28800 (8 hours)
3600 (1 hour)
Local IPSecID LAN IP Address
GW_A 192.168.0.1
GW_B 192.168.3.1
N300 Wireless ADSL2+ Modem Router DGN2200
Set Up VPN Tunnels in Special
Internet
GtoGr
12345678
N/A Main Mode
N/A Enabled
N/A DES
N/A MD5
N/A Group 1
Subnet Mask
255.255.255.0
255.255.255.0
IP:192.168.3.1
22.23.24.25
Gateway B
N/A
N/A
Manual Keys
Disabled
3DES
SHA-1
Group 2
N/A
N/A
FQDN or Gateway
IP (WAN IP
Address)
14.15.16.17
22.23.24.25