Delete A Vpn Tunnel; Set Up Vpn Tunnels In Special Circumstances; Use Auto Policy To Configure Vpn Tunnels - NETGEAR DGN2200v1 User Manual

Delete a VPN Tunnel

Select Advanced - VPN > VPN Policies to display the VPN Policies screen.
1.
In the Policy Table, select the radio button for the VPN tunnel to be deleted, and then click
2.
Delete.

Set Up VPN Tunnels in Special Circumstances

When the VPN Wizard and its VPNC defaults (see
for your circumstances, use one of these alternatives:
Auto Policy. For a typical automated Internet Key Exchange (IKE) setup, see
•
Policy to Configure VPN Tunnels
the authentication scheme and automatically generate the encryption keys.
Manual Policy. For a manual keying setup in which you have to specify each phase of
•
the connection, see
policy does not use IKE. Rather, you manually enter all the authentication and key
parameters. You have more control over the process; however, the process is more
complex, and there are more opportunities for errors or configuration mismatches
between your DGN2200 and the corresponding VPN endpoint gateway or client
workstation.

Use Auto Policy to Configure VPN Tunnels

You need to configure matching VPN settings on both VPN endpoints. The outbound VPN
settings on one end has to match to the inbound VPN settings on other end, and vice versa.
See
Example of Using Auto Policy
Configure VPN Network Connection Parameters
All VPN tunnels on the modem router require that you configure several network parameters.
This section describes those parameters and how to access them.
118 | Chapter 8. Virtual Private Networking
on page 118. Auto Policy uses the IKE protocol to define
Use Manual Policy to Configure VPN Tunnels
on page 122 for an example of using Auto Policy.
N300 Wireless ADSL2+ Modem Router DGN2200
on page 97) are not appropriate
Table 4
on page 125. Manual
Use Auto