Add a Static Route
Select Advanced > Static Routes to display the following screen:
1.
Click Add to open the following screen.
2.
Fill in the fields:
3.
In the Route Name field, enter a route name for this static route. This name is for
•
identification purpose only.
Select Private if you want to limit access to the LAN only. The static route will not be
•
reported in RIP.
Select Active to make this route effective.
•
Enter the destination IP address of the final destination.
•
Enter the IP subnet mask for this destination. If the destination is a single host, type
•
255.255.255.255.
Enter the gateway IP address, which has to be a router on the same LAN segment as
•
the modem router.
In the Metric field, enter a number between 2 and 15 as the metric value. This
•
represents the number of routers between your network and the destination. Usually,
a setting of 2 or 3 works.
Click Apply to save your changes. The Static Routes table is updated to show the new
4.
entry.
84 |
Chapter 7. Advanced Settings
N300 Wireless ADSL2+ Modem Router DGN2200