Setting Up A Gateway-To-Gateway Vpn Configuration - NETGEAR DGND3300v2 - RangeMax Dual Band Wireless-N Modem Router User Manual

Note: Use the active VPN tunnel information and pings to determine
whether a failed connection is due to the VPN tunnel or some reason
outside the VPN tunnel.
9. The Connection Monitor screen for this connection is shown in the following figure:
In this example you can see these settings:
• The N300 wireless modem router has a GW address (public IP WAN address) of
22.23.24.25.
• The N300 wireless modem router has a remote address (LAN IP address) of 192.168.3.1.
• The VPN client PC has a local address (dynamically assigned address) of 192.168.2.2.
While the connection is being established, the Connection Name field in this screen displays
SA before the name of the connection. When the connection is successful, the SA changes
to the yellow key symbol shown in the previous figure.
Note: While your PC is connected to a remote LAN through a VPN, you
might not have normal Internet access. If this is the case, you must
close the VPN connection to have normal Internet access.

Setting Up a Gateway-to-Gateway VPN Configuration

Note: This section describes how to use the VPN Wizard to set up the
VPN tunnel using the VPNC default parameters listed in
page 79. If you have special requirements not covered by these
VPNC-recommended parameters, see
Special Circumstances
up the VPN tunnel.
90 | Chapter 6. Virtual Private Networking
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
on page 100 for information about how to set
Table 2
Setting Up VPN Tunnels in
on