Step-By-Step Configuration - NETGEAR DGN2200v1 User Manual

10.506.0/24
Gateway A
(DGN2200)
LAN IP
10.5.6.1
Figure 28. VPNC Example, Network Interface Addressing

Step-by-Step Configuration

Use the VPN Wizard to configure Gateway A (DGN2200) for a gateway-to-gateway
1.
tunnel (see
Set Up a Gateway-to-Gateway VPN Configuration
certain to use appropriate network addresses for the environment.
The LAN addresses used in this example are as follows:
Table 10.
Unit
DGN2200
FVL328
a. Enter toGW_B for the connection name.
b. Enter 22.23.24.25 for the remote WAN's IP address.
c. Enter the following:
IP Address. 172.23.9.1
•
Subnet Mask. 255.255.255.0
•
d. In the Summary screen, click Done.
Use the VPN Wizard to configure the Gateway B for a gateway-to-gateway tunnel (see
2.
Up a Gateway-to-Gateway VPN Configuration
appropriate network addresses for the environment.
a. Enter toGW_A for the connection name.
b. Enter 14.15.16.17 for the remote WAN's IP address.
c. Enter the following:
IP Address. 10.5.6.1
•
Subnet Mask. 255.255.255.0
•
d. In the Summary screen, click Done.
144 | Appendix B. NETGEAR VPN Configuration
N300 Wireless ADSL2+ Modem Router DGN2200
Internet
WAN IP
14.15.16.17
WAN IP
14.15.16.17
22.13.24.25
Gateway B
WAN IP
22.23.24.25
on page 108), being
LAN IP
10.5.6.1
172.23.9.1
on page 108), being certain to use
172.23.9.0/24
LAN IP
172.23.9.1
LAN Subnet Mask
255.255.255.0
255.255.255.0
Set