Troubleshooting With The Leds; Power Led Is Off; Power Led Is Red - NETGEAR DGN2200v1 User Manual

N300 Wireless ADSL2+ Modem Router DGN2200

Troubleshooting with the LEDs

When you turn the power on, the power, LAN, and DSL LEDs should light as described here.
If they do not, refer to the sections that follow for help.
When power is first applied, the Power LED lights.
1.
After approximately 10 seconds, the LAN and DSL LEDs light as follows:
2.
a. The LAN port LEDs light for any local ports that are connected.
b. The DSL link LED lights to indicate that there is a link to the connected device.
c. If a LAN port is connected to a 100 Mbps device, verify that the LAN port's LED is
green. Note that if the LAN port is 10 Mbps, the LED is amber.
Power
Figure 23. Front panel LEDs

Power LED Is Off

If the Power and other LEDs are off when your modem router is turned on:
Check that the power cord is correctly connected to your modem router and the power
•
supply adapter is correctly connected to a functioning power outlet.
Check that you are using the 12 V DC power adapter supplied by NETGEAR for this
•
product.
If the error persists, you could have a hardware problem and should contact NETGEAR
Technical Support.

Power LED Is Red

When the modem router is turned on, it performs a power-on self-test. If the Power LED turns
red after a few seconds or at any other time during normal operation, there is a fault within
the modem router.
LAN Ports (1–4) USB DSL Internet Wireless
Chapter 9. Troubleshooting
WPS
| 129