Table of Contents
Advertisement
Factory Reset
This function resets the BNX3 to its original factory settings. This procedure erases ALL custom user
presets, utility settings, and re-calibration of the Expression Pedal. The procedure for performing a
Factory Reset is as follows:
NOTE: Performing this function will erase all user-programmed data. Be sure you want to
erase the memory and start fresh before continuing with this procedure. A factory
reset does not erase the internal or external recorder memory.
1. Press the UTILITY button.The Utility button's LED lights.
2. Using the MODE or DRUMS buttons, scroll to the left or right until
3. Rotate the DATA WHEEL clockwise, until the display reads
NOTE: This procedure resets ALL user settings. Rotate the DATA WHEEL
counterclockwise, or press EXIT while NO is blinking in the display to abort.
4. Press the DRUMS button. Yes begins blinking in the display.
5. Press STORE to reset the BNX3. The display returns to the Reset screen.
6. Press EXIT to return to the BNX3 presets.
Formatting Recorder Memory
In the unlikely event the recorder memory (either internal or external) fails to work, it may need to be
reformatted. If internal memory is to be reformatted, remove any memory cards from the BNX3's
Memory Card slot before performing this procedure. If external memory cards are to be reformatted,
insert them into the Memory Card slot before performing this procedure
NOTE: Performing this procedure will erase all recorded information from either internal or
external memory. Be sure you want to erase this memory before continuing with
this procedure.
To reformat the BNX3's recorder memory follow these steps:
1. Begin with the BNX3's power turned off.
2. Press and hold the RECORD button on the BNX3's recorder panel and turn the power on.
3.When the BNX3's main display reads
red.
4. Press the RECORD button to begin the recorder memory formatting procedure. The display read
erasing
while the procedure is in progress. When completed, the display returns to the preset
screen.
G
E
™ Editor/Librarian
EN
DIT
The possibilities are endless when you install the G
computer. Before installing G
BNX3's MIDI input, and the BNX3's MIDI output to the computer's MIDI input.Then insert the
G
E
™ CD ROM into the CD ROM drive on your computer, and follow the install instructions that
EN
DIT
appear on the screen.
PC
If the install instructions do not appear automatically after inserting the CD, select RUN from the
Start menu, and double-click SETUP.EXE located on the CD ROM drive.
format?
, release the RECORD button. It will now be flashing
EN
E
™ on your Mac or PC, connect the computer's MIDI output to the
EN
DIT
Other Functions
RESET
NO Yes
(No Yes) and NO is blinking.
E
™ Editor/Librarian software on your home
DIT
(Reset) is displayed.
71
Hide quick links:
Advertisement
Table of Contents
