S/Pdif Digital Output; Setting Output Level - DigiTech GeNetX BNX3 User Manual

1. Connect the bass to the BNX3's input.
2. Connect the Low Output to the Amp Channel that feeds the low frequency driver or cabinet.
3. Connect the High Output to the Amp Channel that feeds the high frequency driver or cabinet.
4.Turn on the BNX3.
5. Select Bi-Amp as the output configuration from the Utility menu. Set the crossover frequency no
lower then the high frequency driver's recommended rating. See page 66 for more information on
selecting the Output configuration.
NOTE:The recorder output is not heard in the analog outputs when Bi-Amp setup is used.
Low Input
High Input
2 - Channel
Stereo
Power Amp
High Freq
Cabinet
Low Freq
Cabinet

S/PDIF Digital Output

Connect the BNX3's S/PDIF output to the S/PDIF input on your digital audio compatible mixer or
computer sound card. You must have S/PDIF inputs on the receiving device in order to use this
output. Be sure to use a 75 ohm or RCA video cable to connect from the Digital Output to the
input of the other device. The BNX3 must be setup as the Master (the clock source), on the
receiving device, when using this output. You can use the analog and digital outputs of the BNX3
simultaneously.
NOTE: Do not connect the S/PDIF output to analog auxiliary, CD, phono, or tape inputs on
mixers or consumer electronic devices. It is not compatible with these inputs.

Setting Output Level

1. Once the audio connections are made, turn the BNX3's Output Level, on the rear panel, all the way
down (counterclockwise).
Right/High Left/Low
Output Output
Introduction
9