Stereo Record - DigiTech GeNetX BNX3 User Manual

Recorder
bass DRY
– Select this input to route a dry, unprocessed bass signal direct from the input to the
recorder while processed signal is heard at the BNX3's outputs. This input is great for laying down a dry
bass track that can be replayed through different amp models and presets using the Reamp input . You
can still monitor the bass signal through all of the BNX3's effects processing while recording.
bass AMP
– Select this input to tap the bass signal right after the Noise Gate, and send it to the
recorder, while a processed signal is heard at the BNX3's outputs. This mode is great for laying down a
dry bass amp track without modulation, delay, or reverb effects but still monitoring these effects out the
BNX3's outputs while recording.
REAMP 1-8
– Select one of these inputs to route the selected track back through the current BNX3's
preset. This is great for bass tracks that were recorded using
experiment by playing these tracks back through different amp models, effects, or entirely new presets.
This is exactly how professional recording engineers mix down bass tracks. To select the input
configuration for recording, follow these steps:
1. Begin with the recorder stopped.
2. Press the SETUP button once. The BNX3's main display reads
selected input configuration. Default from the factory is
3. Use the DATA WHEEL to select one of the 10 different input configurations you want to use for
recording.
4.When finished, press EXIT.
NOTE: When the STOP button is pressed after using the
recording, the input configuration will automatically be reset to

Stereo Record

The recorder can be setup to automatically arm pairs of tracks for recording in stereo. When Stereo
Record is enabled, each time you press the RECORD button or footswitch, the recorder will
automatically arm a pair of tracks to record to. Each track is automatically panned hard left and hard
right respectively to maintain a stereo image. Track 1 is paired with track 2, track 3 is paired with track 4,
and so on. To use Stereo Record, follow these steps:
40
bass DRY bass AMP
or
recinput
. The display flashes the
bass
.
reamp
input configuration for
because you can
bass
.