About The Bnx3; The Presets; The Bnx3'S Modes; Bank Mode - DigiTech GeNetX BNX3 User Manual

Introduction
2. Turn the power to your amplifier(s) on.
3. Set the amp(s) to a clean tone and set the tone controls to a flat EQ response (on most amps, this
would be 0 or 5 on the tone controls).
4. Turn the Output Level of the BNX3 up to increase the volume.

About the BNX3

The Presets

A preset is a named and numbered location of a programmed sound that resides in the BNX3. Presets
can be recalled with the FOOTSWITCHES or the DATA WHEEL. The BNX3 comes with 65
Factory and 65 User presets. The Factory Presets do not let you store changes to them. The User
presets let you store changes. From the factory, the 65 User presets are exact duplicates of the 65
Factory presets. This lets you create your own presets without worrying about losing any of the original
presets. When you select a preset, the name of the preset appears in the green alpha-numeric display and
the number of the preset appears in the red numeric display. The User LED to the right of the numeric
display lights indicating the User preset is active. The Factory LED lights indicating a Factory preset is
active.

The BNX3's Modes

When you first apply power to the BNX3, it powers up in one of three modes: Bank, Stompbox, or
Recorder. Modes are selected in two different ways:
1. Press the MODE button (located to the right of the DATA WHEEL).
2. Press FOOTSWITCHES 4 and 5 simultaneously.
Depending on which mode is selected, the UP/DOWN footswitches and Mode Button light a different
color. When Bank mode is selected, these footswitches are lit green (this is the default mode from the
factory). When Stompbox mode is selected, these footswitches are lit yellow. And when Recorder mode
is selected, these footswitches are lit red. In any of the modes, the display shows the selected preset's
name and number. The vertical LEDs on the Matrix indicate which effects are active for the selected
preset.

Bank Mode

When Bank Mode is active the UP/DOWN footswitches are used to select the 13 User Banks.
Successive presses of the UP/DOWN footswitches advances through all User/Factory Banks. Pressing
and holding a UP/DOWN footswitches scrolls through the User Banks. Once a Bank is selected, a
preset within that bank needs to be selected. If a preset is not selected within 5 seconds, the BNX3
returns to the previous bank and preset.
10
OR