Tutorial; Select A Preset; Create A Hypermodel; Select The Green Channel Amp And Cabinet - DigiTech GeNetX BNX3 User Manual

Tutorial

Tutorial
Suppose you wanted to create your own HyperModel™ that incorporates the sweet tone of a Vintage bass
Vntg8x10
amp using a
Let's also suppose that you want to be able to toggle between the Fuzz amp and this new HyperModel™
with a preset that uses no Compression, has a Noise Gate that opens quickly, a subtle Chorus effect, no
Delay, and a little bit of a Hall reverb.The following steps guide you through the process of creating just that
preset in the BNX3.

Select a Preset

The first step to create a preset is to select your starting point. You can start with any preset, but for this
example let's start with Preset 40. Use the Footswitches or the Data Wheel to select Preset 40.

Create a HyperModel™

1. Select Preset 40. The BNX3 is ready to select the Amp Models (indicated by the Status button's yellow
LED).

Select the Green Channel Amp and Cabinet

The LEDs next to the Parameter 1 and Parameter 2 knobs are green indicating you can select the Amp
and Cabinet types for the Green Channel. To assign the Vintage bass amp to the Green Channel, do the
following:
1. Rotate the Parameter 1 knob until the display reads
2. Rotate the Parameter 2 knob until the display reads

Select the Red Channel Amp and Cabinet

The LEDs next to the Parameter 4 and 5 knobs are red indicating you can select the Amp and Cabinet
types for the Red Channel.To assign the Ashdown amp to the Red Channel, do the following:
1. Rotate the Parameter 4 knob until the display reads
2. Rotate the Parameter 5 knob until the display reads
30
cabinet, and the thick bottom end of a boutique bass amp with an
Vintage
Vintage
(Vintage).
VNTG8x10
( Vintage 8x10).
vntg8x10
ASH DOWN
(Ashdown).
ASH 4X10 (Ash 4x10).
Ash 4x10
cabinet.