Quantize; Record Quality - DigiTech GeNetX BNX3 User Manual

Recorder
autostop
1. Press the SETUP button until appears in the BNX3's main display. The Auto Stop menu
appears in the display.
2. Use the DATA WHEEL to turn the Auto Stop feature on and off.
3. Press the EXIT button to exit setup.

Quantize

This option is used only when the BNX3's recorder uses a JamMan™ delay looper. The Quantize
function creates perfectly timed loops to the nearest eighth note of a given tempo. Therefore, if you set
a loop length just a little too long to sync with the recorder click track or the BNX3's drum machine, the
quantize function pulls in the actual loop length to make it sync up exactly with the tempo you have
selected. More about this is found in the JamMan delay looper section of this manual. To setup the
Quantize function, follow these steps:
1. Begin with the recorder stopped.
2. Press the SETUP button until the BNX3's main display reads Quantize .
3. Use the DATA wheel to turn the quantize function on or off.
4.When finished, press EXIT.

Record Quality

Cd
There are 3 different recording qualities the BNX3's recorder can record in. is the highest quality the
BNX3's recorder offers and is the default setting from the factory. It is a true 44.1kHz CD quality sample
rate but limits recording time the most. LP is the middle recording quality that doubles the amount of
recording time that CD quality offers. eP is the BNX3's most economical recording quality. It has four
times the amount of recording time as CD quality. The higher the selected quality, the shorter the total
amount of available recording time. To setup the song's record quality, follow these steps:
44