Select Models For The Preset's Channels; Edit The Preset; Turn The Compressor/Fretless Simulator Off - DigiTech GeNetX BNX3 User Manual

4. When the display reads
choose one of the 9 User HyperModel™ locations.The alpha-numeric display should read
(Empty) and the red numeric display should read
BNX3.
5. Press the AMP SAVE button again to save to this Amp location.The display briefly reads
(Amp Saved) and then returns to the name of the selected preset.

Select Models for the Preset's Channels

In the previous steps, you selected a Vintage bass amp model for the Green Channel and an Ashdown amp
model for the Red Channel. Then you Warped the two together to create our HyperModel™. This
HyperModel™ is saved as an amp type that you named VNTGASH, but it is not currently part of your preset.
In this example preset, you need to be able to toggle between a Fuzz bass simulation and your new
HyperModel™. To do this you need to select the Fuzz model for the Green Channel and VNTGASH for the
Red Channel of your preset, as follows:
1. The LED next to the STATUS button should be yellow. If it is not, press EXIT.
2. Rotate the Parameter 1 knob until the display reads
preset.
3. Rotate the Parameter 4 knob until the display reads
Red Channel Model for the preset. This lets you toggle between these two sounds using the Amp
Footswitch (when Stompbox Mode is active).

Edit the Preset

The next step to creating our example preset involves editing the preset. To edit the preset, do the following:

Turn the Compressor/Fretless Simulator Off

1. Press the EFFECT SELECT DOWN button. The Matrix LED in the Comp/Fretless row lights.
The display briefly reads
2. If the red display reads
(since our example does not use the compressor).
VNTGASH
, press the AMP SAVE button again. Use the DATA WHEEL to
EDIT
and then cycles between the status of the Compressor/Fretless effects.
Cmp/Fret On
, press the STATUS button once to turn the compressor off
U1
if this is the first HyperModel™ stored to your
fuzz
.This is the Green Channel Model for the
VNTGASH
(our new HyperModel™). This is the
Tutorial
EMPTY
AMP SaVD
33