Introduction
Quick Start
The Quick Start section is included for those of you who would rather play now and read later.
Making Connections
1. Connect your instrument to the INPUT jack on the rear panel.
2. Connect the LEFT/RIGHT OUTPUTS to the input(s) of your amplifier(s), power amp, or mixer.
Note: See page 66 for Bi-Amp feature
Apply Power
1.Turn the OUTPUT level knob, on the rear panel of the BNX3, all the way down (fully counter
clockwise).
2. Connect the PSS3 power supply to the POWER jack on the BNX3.
3. Connect the other end of the PSS3 power supply to an AC outlet.
4.Turn the BNX3 POWER switch on.
5.Turn your amplifier(s) on, and adjust the volume(s) to a normal playing level. Gradually turn up the
BNX3's OUTPUT level.
Select an Analog Output Mode
1. Press the UTILITY button.
2. Rotate the DATA WHEEL to select an output mode.
3. Select one of the following settings:
sterbass
BiAmp
, or
Select a Preset
The BNX3 comes with 65 pre-programmed Factory Presets, and 65 User Presets. From the factory, the
User Presets are exact duplicates of the Factory Presets.
1. Press the UP/DOWN footswitches to select a Bank.
2. Press Footswitches 1-5 to select a preset, or rotate the DATA WHEEL.
Note: To edit a preset, see page 14.
2
mono
,
stereo
.
,
b>l r>r
(bass>left recorder>right),
monobass
,