Book.book Page 68 Thursday, April 19, 2001 4:21 PM
68
Chapter 3 Managing the BayStack 10 PSU
Changing SNMP and system information
The screen shown in
system information, as well as network and console parameters.
Figure 26 Screen displaying SNMP and system information
System Configuration
----------------------------------------------------------------
NETWORK PARAMETERS:
-------------------
IP address on LAN is 10.170.134.56
LAN interface's subnet mask is 255.255.255.0
IP address of default gateway to other networks is 10.170.134.3
CONSOLE PARAMETERS:
-------------------
Console channel will use a baud rate of 9600
BOARD PARAMETERS:
-----------------
Processor:
Board Info:
Board Memory: FLASH : 4Mbytes
Board's Ethernet hardware address is : 0:E0:7B:CC:77:22
SNMP PARAMETERS:
---------------
System name:
System contact:
System Location: San Jose Ca. 95356
----------------------------------------------------------------
To change any of this,press any key within 10 seconds
208296-C
Figure 26
allows you to change the SNMP variables and the
MPC850, Running at 50Mhz
Management Board
SDRAM : 4Mbytes
BayStack 10
Peggy Murphy