Book.book Page 49 Thursday, April 19, 2001 4:21 PM
To install a power supply module:
1
Figure 19 Removing a rear cover plate
2
3
4
5
Connecting the DC connector cables
After you install the power supply modules, you are ready to connect the cables.
You must install the DC connector cable from the power supply modules to other
devices before you turn the power on to the BayStack 10 PSU. Each of the two
power supply modules requires a specific cable. Use only the cable supplied with
the specific module. Then connect the power cable and turn the power on to the
unit.
Remove one of the cover plates on the rear of the chassis
Insert a power supply module into the empty slot.
Verify that the module is firmly seated in the slot.
Use a screwdriver to tighten the two screws fastened onto the module to the
chassis to secure the power supply module.
Torque the screws to 10 inch-pounds.
(Figure
19).
9658FA