Figure 21 Baystack 10 Rps Controller Module Power Receptacle - Nortel 10 Installation And Reference Manual

Book.book Page 52 Thursday, April 19, 2001 4:21 PM
Table 5 International power cord specifications (continued)
Country/Plug description
Australia:
•
To connect the power cable:
1
Figure 21
To AC outlet
2
AS3112-1981 Male plug
Connect one end of the power cable to the power receptacle on the rear panel
of the chassis (Figure 21).
BayStack 10 RPS controller module
Attach the other end of the power cable to a standard AC wall outlet. Use only
the correct country-specific cable for the power source.
Note: When you connect the AC power with only the RPS modules,
the BayStack 10 PSU powers up immediately. The BayStack 10 PSU
functioning without the UPS modules does not have a power on/off
switch.
Specifications Typical plug
240 VAC
50 Hz
Single phase
power receptacle
CONSOLE
ETHERNET
AC
IN
9646EA
230FA