Figure 15 Connecting The Chassis Wires To The Batteries - Nortel 10 Installation And Reference Manual

Book.book Page 38 Thursday, April 19, 2001 4:21 PM
38 Chapter 1 Introduction
7
8

Figure 15 Connecting the chassis wires to the batteries

Black
Wire
B a y S ta
9
10 Use the screws that you saved from the blank plate to secure the battery pack
208296-C
Insert the battery pack drawer into the left front slot.
Insert the battery pack along the left side of the drawer. Connect the internal
chassis 10 AWG wires (one red wire, one black wire) to the poles at each side
of the batteries (Figure
has a red window next to it. Connect the black wire to the negative pole,
which has a black window next to it
Red Wire
c k 1 0
P o w e r
S u p p ly
U n it
Warning: Be sure to match the polarity of the wires to the polarity of
the poles on the battery.
Note: A spark may occur when you connect the internal wires to the
battery pack—this is normal functioning.
Carefully, slide the battery pack module fully into the compartment.
Ensure that the battery pack drawer is fully seated in the chassis.
module to the chassis.
15). Connect the red wire to the positive pole, which
UP S
SY ST EM
BR BL
BO BU
1 2
CH AR GE 3
4
LO AD
RP SU
Do wn On
EN VI RO
NM EN T
Po we r Of f
1 2
3
4
FF
AC
BS
OT
N
10057FA