Installing The Ups And Battery Pack Module; Figure 13 Battery Pack Module; Table 4 Ups Output Voltage And Current - Nortel 10 Installation And Reference Manual

Book.book Page 36 Thursday, April 19, 2001 4:21 PM
36 Chapter 1 Introduction

Installing the UPS and battery pack module

Your BayStack 10 PSU chassis is shipped without the UPS or RPS installed. If
you have already installed the RPS controller module, you must remove it before
installing the UPS module. Be sure to turn off power to the controller module by
unplugging the power cable before you remove the RPS controller module.
Table 4
module for North America and Japan, and the UPS module for Europe.

Table 4 UPS output voltage and current

UPS for North America and Japan
Input:
Output:
UPS for Europe
Input:
Output:
To provide uninterruptible power to your equipment, you must install the UPS and
its battery pack module into the BayStack 10 PSU.
of the battery pack module.

Figure 13 Battery pack module

B a y S ta
208296-C
displays the output voltage and current for each UPS module: the UPS
100/120 V AC, 12 A, 60 Hz
100 V AC, 12 A, 60 Hz, 1200 VA, 1000 W, pf: 0.83
120 V AC, 12 A, 60 Hz, 1400 VA, 1000 W, pf: 0.7
230 V AC, 7 A, 50 Hz
230 V AC, 7 A, 50 Hz, 1400 VA, 1000 W
c k 1 0
P o w e r
S u p p ly
U n it
Figure 13
10056FA
shows an illustration