Features; Ups Module; Iec Connectors - Nortel 10 Installation And Reference Manual

Book.book Page 32 Thursday, April 19, 2001 4:21 PM
32 Chapter 1 Introduction

Features

The features of the UPS module are:
•
•
•
•
•
•
•
•
•

UPS module

The UPS module of the BayStack 10 PSU contains SNMP management software,
similar to the software in the RPS controller module. The UPS module also
includes a battery charger, front panel LEDs, and rear panel power and
management connectors. The battery charger in the UPS module supplies backup
power to the battery. Refer to

IEC connectors

The rear panel of the UPS contains four IEC power receptacles, as well as the IEC
receptacle that connects the BayStack 10 PSU to a standard AC power outlet.
Use the IEC-to-IEC cables provided with the UPS to connect to the devices you
need to provide with power. You must connect to the same devices that are also
connected to the power supply modules of the RPS section of the device.
The IEC connector on the far left side of the UPS rear panel
the BayStack 10 PSU to a standard AC power outlet.
208296-C
1,400 V A (volt-amperes)
Battery, hot-swappable
Surge protection
True sine wave output (is phase-locked to input power)
SNMP control and management
Configurable IP address of BayStack 10 PSU
Performance monitoring
Identification of power supply modules
No minimum load required
"LEDs" on page 18 for information about the LEDs.
(Figure 11) connects