Book.book Page 48 Thursday, April 19, 2001 4:21 PM
To install the chassis on a flat surface:
Optional rubber feet are provided. When installed properly, they prevent the unit
from slipping.
To install the optional rubber feet:
1
2
Installing the power supply modules
To prevent damage during shipping, the power supply modules are not installed
into the BayStack 10 PSU. Install these modules before attempting to power on
the chassis and connected devices. You can install up to four modules into any of
the four slots in the rear of the chassis (as described in
on page
supply module.
Repeat the installation instructions as needed. The power supply modules are
hot-swappable.
Place the unit on a sturdy, level surface.
Caution: For proper ventilation, be sure that the chassis has at least
2 inches (5.1 cm) of space on each side. Restricted airflow causes
overheating of the internal components. Be sure to provide adequate
ventilation space on the sides of the chassis.
Remove the paper backing from each rubber foot.
Place one foot on each corner on the bottom of the unit.
28). The following instructions apply to the installation of any power
Caution: If you are not installing a module in any of the slots, be sure
to keep the metal cover plate in place over the slot. Removing the cover
plate impedes airflow and proper cooling of the unit.
"Power supply modules"