Connecting The Antenna Terminals; Connecting A Cd Player; Connecting A Turntable - Denon DRA-CX3 Operating Instructions Manual

ENGLISH

Connecting the antenna terminals

An FM antenna can be connected directly.
Direction of broadcasting station
FM outdoor antenna
FM antenna
(Supplied)
7 Ω/ohm coaxial
cable
Assembling the AM loop antenna
Connect to the AM
antenna terminals.
1 2
3
Remove the vinyl
Bend in the reverse
tie and take out the
direction.
connection line.
4
a. With the antenna on
top any stable surface.
Mount
b. With the antenna
attached to a wall.
Installation hole Mount on wall, etc.
AM loop antenna
(Supplied)
Black White
AM outdoor antenna
Ground
Connecting the AM loop antenna
1. Insert the antenna wire while
pressing the lever.
2. Release the lever to lock the
antenna wire in place.
NOTE:
• Do not connect two
simultaneously.
• Even if an AM outdoor antenna is used, do not
disconnect the AM loop antenna.
• It is not possible to receive AM broadcasts
with good quality if the AM loop antenna is
near something metallic.

Connecting a CD player

Connecting a turntable

• If connecting the turntable ground wire causes noise, disconnect it.
For instructions on connecting the turntable ground wire, refer to the operating instructions included with
the turntable.
• Set the CARTRIDGE selection switch to "MM" or "MC" according to the cartridge being used.
FM antennas
NOTE:
• If a turntable is not connected to the PHONO input terminals, do not select PHONO since this can
cause humming and noise, especially if the volume is turned up high.
When not connecting a turntable, leave the included short-circuiting pin plugged in.
• The DRA-CX3's SIGNAL GND terminal (

ENGLISH
CD player
A
L L
R R
Turntable
A
L
R
) is not a safety ground.