Connecting The Antenna Terminals; Connecting The Xm Terminal - Denon AVR-4306 Operating Instructions Manual

Connecting Other Sources

Connecting the antenna terminals

An F-type FM antenna cable plug can be connected directly.
Direction of broadcasting station
FM antenna
75 /ohms
Coaxial cable
FM indoor antenna
(Supplied)
2 AM loop antenna assembly
Connect to the AM
antenna terminals.
1 2
3
Remove the vinyl tie
Bend in the reverse
and take out the
direction.
connection line.
4
a. With the antenna
on top any stable
surface.
Mount
b. With the antenna
attached to a wall.
Installation hole Mount on wall, etc.
AM loop antenna
(Supplied)
AM outdoor antenna
GROUND
Connection of AM antennas
1. Push the 2. Insert the
lever. conductor.
NOTE:
• Do not connect two FM antennas
simultaneously.
• Even if an external AM antenna is used, do
not disconnect the AM loop antenna.
• Make sure the AM loop antenna lead
terminals do not touch metal parts of the
panel.
Note to CATV system installer:
This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC which provides guidelines for
proper grounding and, in particular, specifies
that the cable ground shall be connected to
the grounding system of the building, as
close to the point of cable entry as practical.

Connecting the XM terminal

• AVR-4306 is the XM Ready® receiver. You can receive XM Satellite Radio® by connecting to the
XM Connect-and-Play
• Plug the XM Connect-and-Play antenna into XM terminal on the rear panel.
• Position the XM Connect-and-Play antenna near a south-facing window to receive the best signal.
For details, see "XM Satellite Radio" (
When making connections, also refer to the operating instructions of the XM Connect-and-Play
antenna.
NOTE:
• Keep the power supply cord unplugged until the XM Connect-and-Play antenna connection
have been completed.
3. Return the
lever.
21
TM (sold separately) and subscribing the XM service.
page 42).
Connecting Other Sources
XM Connect-and
-Play Antenna