Open Existing Plc - Omron WS02-SIMC1-E - V1.9 REV 02-2009 Operation Manual

Creating a New PLC

3-5-2 Open Existing PLC

15. Clicking the [Connect] button in the [Work CX-Simulator] window will dis-
play the network set to CX-Programmer and its FINS address in the [Guide
to Connect]. Set for the CX-programmer as guided.
Note The details of [Work CX-Simulator] setting will be explained in 3-8 Connecting
to the CX-Programmer.
The Setting information of PLC previously created is saved in the PLC data
folder. Opening the existing PLC enables to use the same setting any times.
1,2,3... 1. Selecting [Select PLC] in the PLC Setup wizard or in the [Settings] of Sys-
tem Status Setting when starting the CX-Simulator will display the [Select
PLC] dialog box.
2. Select [Open an existing PLC] and specify the folder.
Recently-used PLC data folders are selected from the list.
•
Also possible to set by browsing folders with Browse button.
•
3. Click the [OK] button to exit the [Select PLC] dialog box. The Ladder En-
gine is started with the contents set before and each window for Work
CX-Simulator, CX-Simulator Debug Console, and Status is displayed.
4. Clicking the [Connect] button in the [Work CX-Simulator] window will dis-
play the network and its FINS address set to the CX-Programmer in the
[Guide to Connect]. Set to the CX-Programmer guided by the display.
Note The details of [Work CX-Simulator] setting will be explained in 3-8 Connecting
to the CX-Programmer.
Section 3-5
55