Omron WS02-SIMC1-E - V1.9 REV 02-2009 Operation Manual page 237

I/O Memory Allocation
Item
Detect Interrupt Task
Error
EM File EM File
Memory Memory
Settings
EM File
Memory
Starting
Bank
Periph- Peripheral
eral Port Port Set-
Settings tings Selec-
tion
Communi-
cations
mode
Data bits
Stop bits
Parity
CS/CJ-series PLC
Settings
0: Detect This setting determines whether
1: Do not detect interrupt task errors are detected.
If this setting is set to 0 and an
Default: 0 interrupt task error is detected,
the Interrupt Task Error Flag
(A40213) will be turned ON.
0: None This setting determines whether
1: EM File Mem- part of the EM Area will be used
ory Enabled for file memory.
Default: 0
0 to C (0 to 12) If Bit 7 (above) is set to 1, the
setting here specifies the EM
Default: 0 bank where file memory begins.
The specified EM bank and all
subsequent banks will be used as
file memory. This setting will be
disabled if bit 7 is set to 0.
0: Default This setting is effective only when
1: PLC Setup pin 4 of the DIP switch on the
front of the CPU Unit is ON.
Default: 0
00: Host Link This setting determines whether
02: 1:N NT the peripheral port will operate in
Links host link mode or another serial
04: Peripheral communications mode. (Host link
bus can be specified with 00 or 05.)
05: Host Link
Default: 00
0: 7 bits These settings are valid only
1: 8 bits when the communications mode
is set to Host Link.
Default: 0 These settings are also valid only
when the Peripheral Port Settings
0: 2 bits
Selection is set to 1: PLC Setup.
1: 1 bit
Default: 0
00: Even
01: Odd
10: None
Default: 00
Function
Section 9-3
CX-Simulator
Settings Function
Not used.
Same as
CS/CJ-series
PLC.
Same as The EM file
CS/CJ-series memory allo-
PLC. cates the hard
disk of the
same capac-
ity actually.
Not used.
201