Omron WS02-SIMC1-E - V1.9 REV 02-2009 Operation Manual page 239

I/O Memory Allocation
Item
RS-232C Baud rate
Port (bps)
Set-tings
No-protocol
mode delay
CPU Unit's
Unit Num-
ber in Host
Link Mode
No-protocol
Mode
Max. Unit
Number in
NT Link
Mode
Scheduled Interrupt
Time Units
CS/CJ-series PLC
Settings
00: 9,600 Settings 00 and 06 through 0A
01: 300 are valid when the communica-
02: 600 tions mode is set to peripheral
03: 1,200 bus.
04: 2,400 This setting is not valid when the
05: 4,800 communications mode is set to
06: 9,600 NT Link.
07: 19,200
08: 38,400
09: 57,600
0A: 115,200
Default: 00
0000 to 270F: This setting determines the delay
0 to 99990 ms from execution of TXD(236) until
(10-ms units) the data is actually transmitted
from the specified port.
Default: 0
00 to 1F: (0 to 31) This setting determines the CPU
Unit's unit number when it is
Default: 00 connected in a 1-to-N (N=2 to 32)
host link.
00 to FF Start code: Set this start code
only when the start code is en-
Default: 00 abled (1) in bits 12 to 15 of 165.
00 to FF End code: Set this end code only
when the end code is enabled (1)
Default: 00 in bits 8 to 11 of 165.
0: None Start code setting:
1: Code in 164 A setting of 1 enables the start
code in 164 bits 8 to 15.
Default: 0
0: None End code setting
1: Code in 164
2: CR+LF
Default: 0
00: 256 bytes Set this value only when the end
01 to FF: code setting in bits 8 to 11 of 165
1 to 255 bytes is "0: None."
This setting can be used to
Default: 00 change the amount of data that
can be transferred at one time by
TXD(236) or RXD(235). The
default setting is the maximum
value of 256 bytes.
0 to 7 This setting determines the high-
est unit number of PT that can be
Default: 0 connected to the PLC in NT Link
mode.
0: 10 ms This setting determines the time
1: 1.0 ms units used in scheduled interrupt
interval settings.
Default: 0
Function
Section 9-3
CX-Simulator
Settings Function
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Same as
CS/CJ-series
PLC.
Not used.
Same as
CS/CJ-series
PLC.
203