Omron WS02-SIMC1-E - V1.9 REV 02-2009 Operation Manual page 147

Step Run and Break
I/O Break Condition
The I/O break condition is expressed with the following elements for both I/O
Condition and Word Condition.
<Target I/O memory area >(<Condition operator >)(<Value >)
Element
Target I/O memory area Specify the target I/O memory area in its type and
Condition operator
Value
Condition operators (and values for I/O Condition) to be set are shown below.
I/O Condition Value
ON
OFF
NOT
Word Condition
Operator
=
<
>
<=
>=
<>
NOT
address.
For Word Condition, a condition operator exists.
For I/O Condition, set ON/OFF/NOT, for Word Con-
dition the fixed value (BIN), and for NOT operator of
Word Condition nothing.
Contents
The bit value is ON(1)
The bit value is OFF(0)
Hold if the value is changed.
Hold if the value is the same as that of the target I/O
memory area.
Hold if the value is smaller than that of the target I/O
memory area.
Hold if the value is greater than that of the target I/O
memory area.
Hold if the value is equal to or smaller than that of the
target I/O memory area.
Hold if the value is equal to or greater than that of the
target I/O memory area.
Hold if the value is not equal to that of the target I/O
memory area.
Hold if the value has been changed.
Section 4-3
Content
Contents
111