Mounting/Removing Components; Removing The Front Cover; Mounting The Front Cover; Removing The Terminal Cover - Omron VARISPEED V7 User Manual

• The same space is required horizontally and vertically and
right and left for both Open Chassis (IP00, IP20) and
NOTE
Enclosed Wall-mounted (NEMA 1) Inverters.
• Always remove the top and bottom covers before install-
ing a 200 or 400 V Class Inverter with an output of 5.5/7.5
kW in a panel.

Mounting/Removing Components

Removing and Mounting the Digital Operator and Covers

Removing the Front Cover

Use a screwdriver to loosen the screw
(section A) on the front cover. (To pre-
vent loss, this screw cannot be
removed.) Then press the right and left
sides in direction 1 and lift the front
cover in direction 2.

Mounting the Front Cover

Mount the front cover by reversing the
order of the above procedure for
removal.

Removing the Terminal Cover

• 200 V class Inverters with 1.1 kW
and more and all 400 V class
Inverters:
After removing the front cover,
press the right and left sides of the
terminal cover in direction 1 and lift
the terminal cover in direction 2.
3 Mounting
1
2
1
A
25