Memory areas
3-2-1
Configuration of memory areas in the PLC program
3-2-2
Configuration of memory areas in the CJ1W-MCH72
To configure the memory areas for cyclic data exchange in the PLC, you must
use the FINS Parameter Area Write command. For more information on this
FINS command, refer to section 3-4-4.
To configure the memory areas for cyclic data exchange in the CJ1W-MCH72,
you must use the PLC_EXCHANGE BASIC command. For more information
on this BASIC command, refer to section 4-2-181.
Section 3-2
61