Power Switch - Sony SRW-1 Maintenance Manual

5-2-6. POWER Switch

Removal
1. Remove the handle assembly. (Refer to
Section 5-1-1.)
n
When SRPC-1 is not installed, it is not
required to remove the handle assembly.
2. Remove the inside panel assembly.
(Refer to Section 1-6.)
3. Open the APR-65 board.
(Refer to Section 5-1-1.)
4. Open the connector panel.
(Refer to Section 5-2-1.)
5. Loosen the four fixing screws of the fan by
two turns. (Refer to Section 5-4-2.)
6. Turn the two claws of the CNP fan guard in
the arrow direction to take out the harness.
7. Disconnect the harness from the connector
CN112 on the MB-990 board.
8. Cut the two harness clamps of the harness as
shown in the figure.
9. Remove the two screws to remove the
CN2582 bracket from the connector panel.
n
The waterproof rubber (SW) will be detached
from the thread of the POWER switch
attached to the CN2582 bracket. Be careful
not to lose it.
10. Remove the waterproof rubber (SW) from the
POWER switch.
11. Remove the nut fixing the POWER switch to
the CN2582 bracket to remove the POWER
switch (with harness).
SRW-1
Claws
Nut
Waterproof
rubber (SW)
CN2582
B2
bracket
CNP fan guard
CN2582
POWER
bracket
switch
Make parallel
CN112
MB-990 board
B2 x 4
x 4
POWER
switch
5-45 (E)