Removing/Installing Cabinet; Main Body - Sony SRW-1 Maintenance Manual

1-6. Removing/Installing Cabinet

1-6-1. SRW-1 Main Body
1. Handle assembly
1. Loosen the four ornamental screws, and remove the
handle assembly in the arrow direction.
Handle assembly
Ornamental
screws
SRW-1
2. Inside panel assembly
1. Remove the handle assembly.
n
This is not required when SRPC-1 is not installed.
2. Loosen the four screws securing the inside panel
assembly.
3. Disconnect the EJECT harness of the inside panel
Ornamental
assembly from the connector CN401 on the APR-65
screws
board, and then remove the inside panel assembly.
Note for installation
Be careful so that no harness is caught between the chassis
and inside panel assembly when installing the inside panel
assembly.
APR-65 board
CN401
EJECT harness
Screws with stopper
B3 x 12
Inside panel assembly
1-3 (E)