Drive Configuration Jumper
The drive configuration jumpers set your drive to be a
master or slave drive on the EIDE port. The default position
is with the jumper in the Master position. To set the
CRX160E as a slave drive, place the jumper on the Slave
position. The third jumper is for Cable Select.
Audio Out Connector
This connector provides two channel, analog line level
audio output which may be connected to a sound card.
DC Power Inlet
The CRX160E attaches to your PC's standard power cable.
10
CRX160E User's Guide
General Use Suggestions
The CRX160E is intended for installation in a PC and
should be used in an environment suitable for computer
equipment. Dust, moisture and lack of adequate ventilation
are common causes of device failure. You should install
your CRX160E in a location which is:
• Clean
• Dry
• Dust Free
• Out of Direct sunlight
Inserting CD Discs
Put the writable/readable side of the CD media facing
down in the tray, the label side up.
Press the Insert/Eject button to retract the tray.
CAUTION: Insert only CD discs, CD-R or CD-RW media
into the CRX160E CD tray to avoid damaging the unit and
voiding the warranty.
CRX160E User's Guide
• Well Ventilated
11