How To Insert A Cassette Tape With The Outside Panel Assembly; Removed; Precautions For Use Of Condensation Sensor - Sony SRW-1 Maintenance Manual

1-30. How to Insert a Cassette Tape with
the Outside Panel Assembly

Removed

n
Do not use nor press the lid arm (L) when the cassette
compartment assembly is moving down to the DOWN
position in step 4 below.
If the lid arm (L) is pressed, the lid arm (L) may be
deformed. If the lid arm (L) is deformed, the outside lid
assembly may not be locked any more after the outside
panel assembly is reinstalled.
1. Remove the outside lid assembly.
(Refer to Section 1-6-1.)
2. Remove the outside panel assembly.
(Refer to Section 1-6-1.)
3. Move the cassette compartment assembly to the UP
position.
. When the main power is turned on :
Press the EJECT button.
. When the main power is turned off :
Raise the locking roller (WHT) in the direction of
the arrow.
4. Insert a cassette tape to the cassette compartment
assembly.
5. Insert a screwdriver tip or the like into the hole of the
cassette compartment assembly as shown and move
the cassette compartment assembly in the direction of
the arrow until the cassette compartment assembly is
locked. Doing this, the cassette compartment assembly
moves to the DOWN position.
SRW-1
Lid arm (L)
Cassette compartment
assembly
1-31. Precautions for use of
Condensation Sensor
Due to the foreign substances adhering to the condensation
sensor chip (see figure below), the sensor fails to measure
the correct value of residence to humidity. This prevents
the unit from functioning properly. If any foreign sub-
stance gets adhered to the chip, replace the condensation
sensor with a new one.
m
. Do not touch the chip with bare hands.
. Do not clean the chip with alcohol or other similar
agents.
Solders
Bracket
Condensation
sensor chip
Screwdriver
or the like
Locking roller (WHT)
1 pin
Leads Connector
1-43 (E)