Opening/Closing Connector Panel Assembly - Sony SRW-1 Maintenance Manual

3. Disconnect the harnesses from the connectors CN2
and CN5 on the CP-385 board on the control panel
(lower), and disconnect the flexible card wires from
the connectors CN3 and CN4.
4. Remove the control panel (upper).
Control panel (upper)
CN5
CN2
Control panel (lower)
CP-385 board
1-6 (E)
1-7. Opening/Closing Connector Panel
1. Remove the handle assembly. (Refer to Section 1-6-1.)
2. Remove the inside panel assembly.
3. Remove the two screws to open the APR-65 board.
4. Unlock the upper harness clamp on the connector
CN4
CN3
Assembly
(Refer to Section 1-6-1.)
(Refer to Section 5-1-1.)
panel side to release the coaxial cable.
Coaxial cable
Harness clamp
SRW-1