Sensor Holder (Id) Removal/Installation - Sony SRW-1 Maintenance Manual

5-5-21. Sensor Holder (ID) Removal/Installation

Outlines
Replacement
Removing cassette stopper
Removing sensor holder (ID)
Installing sensor holder (ID)
Operation check
Installing cassette stopper
Preparations
1. Turn off the power.
2. Remove the outside lid assembly and the outside panel assembly.
(Refer to Section 1-6.)
n
You can remove/install the sensor holder (ID) without removing the cassette
compartment assembly.
Removal
1. Removing cassette stopper
(1) Disconnect the harness from the connector
CN3 on the SE-741 board.
(2) Remove the two screws to detach the cassette
stopper.
2. Removing sensor holder (ID)
Remove the sensor holder (ID) upward while
pressing the three claws with tweezers or the like.
5-126 (E)
PWH1.4 x 3.5
SE-741 board
(CN3)
Claws
PWH1.4 x 3.5
Cassette stopper
Claw
Sensor holder (ID)
SRW-1