Change [Device] Poll List (Chpl) - Paradyne COMSPHERE 6800 Series Command Reference Manual

COMSPHERE 6800 Series Network Management System

Change [Device] Poll List (chpl)

(Disruptive for DATAPHONE II APL Modems and DSUs, and
3600 Series DSUs When Adding Tributaries)
Use the chpl command to add or delete devices in the poll list of a COMSPHERE
3400/4400 Series modem, a COMSPHERE 3900 Series modem, a COMSPHERE 3600 Series
DSU, a DATAPHONE II APL modem, DSU, or Shared Diagnostic Unit (SDU).
Polling is the process by which alarms from devices in the network are automatically reported to
the NMS. Once a poll list is established for a device, the device monitors everything on its poll list
for health and status.
The NMS polls devices on the control channel. Those devices then poll devices downstream, and
so on through the extended diagnostic network. A device always reports the health and status of all
devices on its poll list to the device that polls it. NMS is, therefore, able to obtain health and status
for all diagnostic devices in the network by polling only devices on the control channel.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Acquire [Device] Poll List (acpl)
Change [Device] Poll List Input Form
There are two pages of the Change [Device] Poll List input form.
Page 1
Page 1 enables you to specify the device(s) for which you want the poll list changed. This input
form contains the following field:
Device(s) (Required field)
2-60
Data Technician, Manager, System Administrator
Abbreviation: chpl
This command is disruptive to DATAPHONE II APL modems and DSUs,
but nondisruptive to SDUs and COMSPHERE APL modems. This
command is disruptive to 3600 Series DSUs when adding tributaries, but is
nondisruptive to these DSUs when deleting tributaries.
Yes
Yes
Display [Device] Poll List (dspl)
Enter the device(s) whose poll lists are to be changed. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User's/System Administrator's Guide.
January 1997 6800-A2-GB31-20